Browsing by Keywords "SolidWorks"
Now showing items 1-10 of 10
-
Route of LPG from gas and oil reservoirs to the end-consumer and its means of storage.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 17-12-2015The present thesis describes the study of the entire route followed by the liquefied petroleum gas (LPG) from gas and oil reservoirs down deep in the earth, where it is found, to the final consumer. Procedures that are ... -
Development of measurement device and performance of models blades small wind turbines.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 16-07-2015This undergraduate project includes the design of a measuring device capable of measuring the performance of small model wind turbine blades at the wind tunnel of Wind Energy Lab of TEI Crete. The design of the device was ... -
Evaluation of prototypes wind turbine blades
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 2016-05-25This undergraduate project includes the development of a small wind turbine's blade through existing blade calculating software that has been created by our department based on aerodynamic formulas with the use of excel. ... -
Theoretical and experimental study of a zero torgue coefficient wing section.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 07-10-2014The NACA 662 215 airfoil is tested in a small wind tunnel and the measurements are compared with numerical calculations. All the three coefficients, CL , CD , Cm are compared with the NACA coefficients as they are edited ... -
Study and design of a wind turbine blade.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 06-08-2013 -
Friction welding machine. Design and function in solidworks.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 26-01-2015There are many few friction welding machines who work in plastics up to 50Hz, in metals to120 or 240Hz. In this thesis we will see 1) the rig welding high frequency linear friction (design, location, experimental procedures ... -
Mechanical design engineering unit for household composting.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 11-09-2014A matter that concerns society in nowdays is the protection of the environment. Recycling and elaborating effuent stations are, now in every big European city. This research is about organic waste and the ways we can reuse ... -
Designing and planning a pulley with SolidWorks.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 20-09-2010 -
Designing an ultralight city vehicle with Solidworks.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 02-07-2012 -
Calculation of aerodynamic coefficients through computer program.
T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
Authors:
Thesis advisor:
Publication Date: 07-07-2015In this undergraduate project, the aerodynamic coefficients for lift-drag are calculated through the Solidworks Flow Simulation programm for the SERI S809 airfoil, and then compared with the experimental data from the ...