Browsing by Keywords "κατασκευή"

Now showing items 1-20 of 25

  • Construction and analysis of a heat anticipation unit for PC.

    T.E.I. of Crete, School of Applied Sciences, Department of Electronic Engineering
    Authors: Tserepas, Stylianos; Christodoulakis, Dimitris
    Thesis advisor: Kouridakis, Stylianos
    Publication Date: 12-04-2011
    In the first chapter: a) air cooling, b) water-cooling and c) extreme cooling. In the second chapter: hardware and steps of construction of water cooling system. In the third chapter: results. In the fourth chapter: conclusions.

  • Frequency filter analysis: simulation and construction of 2nd order 3 roads crossover.

    Η.Μ.U, School of Music and Optoacoustic Technologies (SMOT), Music Technology and Acoustics Dept.
    Authors: Arolithianakis, Fanourios; Biamis, Anastasios
    Thesis advisor: Piotogiannakis, Stylianos
    Publication Date: 2021-04-05
    The present project is about the analysis of frequency filters and aims to create the corresponding simulation and the construction of an active frequency filter (crossover) of 2nd order and 3 roads. Audio equipment ...

  • Investigation of the behavior of a low cost solar heater in Chania - Crete.

    T.E.I. of Crete, School of Applied Sciences, Department of Environmental and Natural Resources Engineering
    Authors: Oikonomou, Anthi
    Thesis advisor: Vourdoumpas, Ioannis
    Publication Date: 28-03-2008
    In the present work a study of simple solar systems of low cost with possibility of application in poor developing countries is presented. It concerns the manufacturing of a simple solar heater that is constituted of two ...

  • Selection and comparison of materials for the construction of optical frames.

    Η.Μ.U, School of Engineering (ScENG), Mechanical Engineering Dept
    Authors: Gastouniotis, Georgios
    Thesis advisor: Papadakis, Nikolaos
    Publication Date: 2023-07-18
    In today's era of rapid development of technology and science, the emergence of new ways of manufacturing products has led scholars to find new methods of designing and manufacturing them. Over the years the materials ...

  • The guitar in rebetiko and folk music

    T.E.I. of Crete, School of Applied Sciences, Department of Music Technology and Acoustics Engineering (in Rethymno)
    Authors: Kotsalos, Alexandros
    Thesis advisor: Kondyli, Georgia; Xenikakis, Dimitrios
    Publication Date: 2018-01-09
    This thesis covers a research on the popular guitar, the evolution and the path towards the urban folk music in Greece, from the late 19th century until nowadays. The dissertation is separated in two parts: the theoretical ...

  • Off-road vehicle prototype - Computational analysis and assembly of parts and accessories.

    T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
    Authors: Gliarmis, Themistoklis
    Thesis advisor: Maniati, Mari-Misel
    Publication Date: 2017-03-10
    This project comprises manufacturing of a two-seater four-wheeled vehicle which is movable on dirt paths. The philosophy and the manufacturing concept of this vehicle is based on buggy and go-cart vehicles. At the same ...

  • Construction of a low speed permanent magnet alternator, output rated 1KW.

    T.E.I. of Crete, School of Applied Sciences, Department of Electronic Engineering
    Authors: Kalaitzakis, Nikolaos
    Thesis advisor: Askordalakis, Pantelis
    Publication Date: 04-06-2013
    Subject of this thesis is the design and construction of an axial-flux, low speed permanent magnet alternator, suitable for a wind turbine.

  • Construction and theoretical treatment of exercises for a lathe.

    T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
    Authors: Theodorou, Thodoris
    Thesis advisor: Papastefanakis, Leonidas
    Publication Date: 19-12-2011

  • Construction and study of mantola (musical instrument).

    T.E.I. of Crete, School of Applied Sciences, Department of Music Technology and Acoustics Engineering (in Rethymno)
    Authors: Tzikas, Vasileios
    Thesis advisor: Tatarakis, Michalil
    Publication Date: 26-10-2009

  • Implementation and study of a GMSK transmitter.

    T.E.I. of Crete, School of Applied Sciences, Department of Electronic Engineering
    Authors: Papoutselis, Dimos
    Thesis advisor: Liodakis, Georgios
    Publication Date: 18-04-2008
    Various modulation methods have been studied, proposed and are in use in today’s wireless communication systems. Furthermore, It’s a challenge for engineers to find IC solutions and implement hardware architectures for ...

  • Construction heterodyne receiver wireless communication in the area of 118-135 MHZ.

    T.E.I. of Crete, School of Applied Sciences, Department of Electronic Engineering
    Authors: Vletsis, Dimitrios
    Thesis advisor: Kouridakis, Stylianos
    Publication Date: 17-07-2013
    The thesis is based on the design and construction of an air receiver that is designed to lesonate at frequencies VHI 118-135 MHZ.

  • Design and construction of a vertical axis wind turbine .

    Η.Μ.U, School of Engineering (ScENG), Electronic Engineering Dept.
    Authors: Kourakis, Nikolaos; Karakonstantis, Marios
    Thesis advisor: Katsigiannis, Ioannis
    Publication Date: 2020-09-21
    This dissertation deals with the design and construction of a Savonius vertical axis wind turbine. More specifically, the dissertation refers extensively to the technologies of Renewable Energy Sources (RES), and focuses ...

  • Design and construction of a yacht.

    T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
    Authors: Bekris, Panagiotis
    Thesis advisor: Petousis, Markos
    Publication Date: 2018-04-26
    The sea, already from the historical times was an irresistible attraction for all societies, Men very fast wanted to conquer it to use its benefits and enjoy its favors. Therefore, they invented the various types of ships ...

  • Detailed study for the construction and use of an artificial lake in the area of Sternes - Kofina in the municipality of Herakleion.

    T.E.I. of Crete, School of Applied Sciences, Department of Environmental and Natural Resources Engineering
    Authors: Mavrogiannis, Angelos
    Thesis advisor: Soupios, Pantelis
    Publication Date: 17-04-2008
    The purpose of this study is the detailed study for the construction and use of an artificial lake in the broader area of Sternes Village in the Municipality of Herakleion. In this work we implemented a variety of well ...

  • Low energy, single phase transformer.

    T.E.I. of Crete, School of Engineering (STEF), Department of Electrical Engineering
    Authors: Mpouris, Michail
    Thesis advisor: Stamatakis, Georgios
    Publication Date: 07-02-2011

  • Design and construction of a wind turbine blade.

    T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
    Authors: Papakostas, Nikitas
    Thesis advisor: Christakis, Dimitrios
    Publication Date: 2016-10-05
    This thesis presents the drawing and the stress calculation of an isostressed blade which will be applied to a generator that delivers a rated power of 1000 watt. The reported generator has the characteristic attributes ...

  • Construction of a small car for short transportations.

    T.E.I. of Crete, School of Engineering (STEF), Department of Mechanical Engineering
    Authors: Antourakis, Markos; Kyriakakis, Konstantinos; Chrysos, Efstratios
    Thesis advisor: Kouridakis, Emmanouil
    Publication Date: 15-02-2011

  • Experimental laser diode of qualification.

    T.E.I. of Crete, School of Applied Sciences, Department of Electronic Engineering
    Authors: Myxakis, Emmanouil
    Thesis advisor: Petridis, Konstantinos
    Publication Date: 05-07-2012
    This thesis is about a structure constisted of a power supply for laser, one photodiode and two lenses which are consentrating the beam. It was conducted for experimental reasons during laboratory activity in the technological ...

  • Design and construction of a photovoltaic solar tracker

    T.E.I. of Crete, School of Engineering (STEF), IPPS Advanced Manufacturing Systems, Automation and Robotics
    Authors: Papoulias, Georgios
    Thesis advisor: Karapidakis, Emmanouil
    Publication Date: 2016-04-18
    This certain thesis has got a target to design and construction of a photovoltaic tracker system of two axes. It concerns an automatic system of detection the position of the sun (known worldwide as solar tracker) based ...

  • Design and constraction of directive antennas for use in wireless networks (Wi-Fi).

    T.E.I. of Crete, School of Applied Sciences, Department of Electronic Engineering
    Authors: Krommidas, Manthos; Raftopoulos, Panagiotis
    Thesis advisor: Zaoutis, Evangelos
    Publication Date: 14-07-2011
    The theme of this thesis is the design and construction of directional antennas for wireless networks using Wi-Fi. The first chapter presents general issues in wireless networks modes of transmission, etc. It also presents ...